Hi,
On target 'arm' sometimes the compiler uses the controller unit. For the codetools I need to know the exact conditions.
What flags indicate that the controller unit is used?
Mattias
Mailing lists / fpc-pascal / 2011-09
arm controller unit
4 messages · 4 people · –
- Florian Klämpfl 1
- Jeppe Græsdal Johansen 1
- Mattias Gaertner 1
- Sven Barth 1
Reply by email Subscribe to this list Your subscription
Read-only archive. Use j and k to move between messages.
Mattias Gaertner wrote 6 lines
Hi,
On target 'arm' sometimes the compiler uses the controller unit.
For the codetools I need to know the exact conditions.
What flags indicate that the controller unit is used?
I personally would say "-Tembedded". Though there could be other triggers as well.
Regards,
Sven
On target 'arm' sometimes the compiler uses the controller unit. For the codetools I need…
Mattias Gaertner wrote 8 lines
Hi,
On target 'arm' sometimes the compiler uses the controller unit.
For the codetools I need to know the exact conditions.
What flags indicate that the controller unit is used?
Mattias
It's at the bottom of loaddefaultunits in pmodules:
{ CPU targets with microcontroller support can add a controller specific unit }
{$if defined(ARM) or defined(AVR)}
if (target_info.system in systems_embedded) and
(current_settings.controllertypect_none) and
(embedded_controllers[current_settings.controllertype].controllerunitstr'') then
AddUnit(embedded_controllers[current_settings.controllertype].controllerunitstr);
{$endif ARM}Where systems_embedded would be any -Tembedded
On target 'arm' sometimes the compiler uses the controller unit. For the codetools I need…
Mattias Gaertner wroteHi, On target 'arm' sometimes the compiler uses the controller unit. For the codetools I need to know the exact conditions.
Only if one a controller is given by -Wp on the command line.