This is not correct, it only counts for MouseUp and Down

+ I'm confused and tired of someone else + please take a look and see what I'm doing wrong. Don't know if Capturing already is implemented, if not I'll 't OK. It uses gtk_grab, this one also grabs the keyboard. The windows

capture only captures the mouse. I changed it to gdk_grab.

+ Do I need to send a WMCANCELMODE message to set the button up?

After some investigations where the CM_MouseEnter and CM_MouseLeave are generated, they appeared in the Application.Idle loop. I started implementing this through gtk_idle_add and a OnIdle event property of the InterfaceBase, but didn't finish

Marc

+ From: Shane Miller
+
+ Argh,

[--8<-- SNIP --8<-- SNIP --8<-- SNIP --8<--]

+ I continue to get MOUSEMOVE meassages until I leave the
+ button. After I leave, I no longer get the messages so I no
+ longer can set it UP again.

If I recall it correctly you've set the MouseCapture on the button down. This way you always get mouseevents regardingless where you are.

So the moment you get a mouse move *Outside* the control you can set up and release the mousecapture.

+ I'm confused and tired of someone else
+ please take a look and see what I'm doing wrong.

Don't know if Capturing already is implemented, if not I'll look at it.

+ Do I need to send a WMCANCELMODE message to set the button up?

Naaahhh...

Marc

Argh,

I am struggling. Can anyone explain something to me.

For the TSpeedbutton's I'm not getting the button to return to it's normal state (FLAT if FLAT is true) when I leave it.

I get the MOUSELEAVE message sometimes, but not others. I am not sure what the problem is because I'm not sure the exact flow that is supposed to be happening.

When I enter the button, the TWincontrol actually gets the MOUSEMOVE message. I do a ControlAtPos to see if there is a non-windowed control at that position. If so, I pass the MOUSEMOVE message on to it.

In Speedbutton I get the mousemove message and because FMOUSEINCONTROL is false I know I just entered it.
I set FMOUSEINCONTROL to TRUE an I call the PAINT procedure. If it's fFlat is true, I set the FState to bsDown and I paint it accordingly.

I continue to get MOUSEMOVE meassages until I leave the button. After I leave, I no longer get the messages so I no longer can set it UP again.

I'm confused and tired of someone else please take a look and see what I'm doing wrong. Do I need to send a WMCANCELMODE message to set the button up? If so, from where?

Thanks
Shane