Hello,

I just wanted to ask if someone already tried to run FPC in QNX 6.2. Few monthes before I run it in QNX4 without bigger problems, but when I run it in QNX 6.2 it stops with segmentation fault. Any ideas?

Regards, Pavel Kanzelsberger

Have you tried 6.1? QNX 4 and 6.x are very different, so this will not help. The QNX newsgroups are littered with posts about porting problems/issues between the was 4 did some things in comparison to 6.X

Matt

---------------------------------------------
This message was sent using Mistral WebMail.
http://www.mistral.co.uk/

Hello, I just wanted to ask if someone already tried to run FPC in QNX 6.2. Few monthes before I run it in QNX4 without bigger problems, but when I run

it

in QNX 6.2 it stops with segmentation fault. Any ideas?

Greetings,
Hmmm... strange indeed, i don't have access to QNX 6.2 so i really can't test it, even though i'd like too... Maybe you can try recompiing the compiler (a simple make cycle OPT=-gl should work) under QNX 4 with the -gl option, and try running it after under QNX 6.2 to check where the crash occurs??

I apologize here, I tried to use Linux version of compiler in QNX. FPC works ok on both QNX4 and QNX 6.x :-))

Regards, Pavel Kanzelsberger