Hi,

I have included the following lines in a "fpg_defines.inc" include file in my project, yet when I compile/build my project, it still shows that compiler hint (as can be seen in the attached screenshot).

// common compiler options
{$mode objfpc}{$H+}
{$interfaces corba}
{$warn 5024 off} // Hint: Parameter "$1" not used

The include file is below the "unit xxx" line, and appears in every unit of my project.

Am I doing something wrong in my project settings? I normally have the -viewnh compiler parameters specified so I can see other hints and warnings. The screenshot output used -vwhilq just so I could confirm I am trying to suppress the correct warning number.... 5024.

FPC 3.0.4 gives the same output. So no better.

Regards,
Graeme

Graeme Geldenhuys wrote

yet when I compile/build my project, it still shows that compiler hint (as can be seen in the attached screenshot).

Is nobody else experiencing this?

Regards,
Graeme

{$warn 5024 off}
procedure TForm1.Edit1Change(Sender: TObject);
begin
   // Do nothing
end;

I get no warning. If I remove the statement, I get the warning.

Michael.

Michael Van Canneyt wrote

I get no warning. If I remove the statement, I get the warning.

Thanks Michael. So it seems it is something local to my system then. I get warnings no matter what.

Do you have any compiler settings like -viewh in your ~/.fpc.cfg file? I'm trying to think what could affect the {$warn xxx off} to not work.

Regards,
Graeme

Op 4/24/2019 om 9:53 AM schreef Graeme Geldenhuys:

Try to put your includes and warnes after the interface statement